Nikon Coolpix P80 v.1.1 Firmware Update

Navigation

(2 votes, average: 5 out of 5)

Loading ...

Nikon has released an update for Nikon Coolpix P80 to version 1.1.

Modifications Enabled with version 1.1 firmware

When shooting with the Vibration Reduction item in the setup menu set to “On”, vibration reduction did not always function in the following situations. This issue has been resolved.
When the camera was turned on, or with ‘recovery from standby mode’ (activated by the “Auto-off” function), and the electronic viewfinder display enabled by pressing the monitor button.
When the camera was turned on, or with recovery from standby mode (activated by the “Auto-off” function), and the camera connected to a televison or other video device via the supplied audio/video cable (EG-CP14)
When shooting with the “Distortion Control” option set to on, excessive correction was sometimes applied. This issue has been resolved.

How to Update:

This service provides software for upgrading the Coolpix P80 firmware to version 1.1. Verify your camera’s firmware version from the “Firmware version” item in the Setup menu. If the firmware version 1.1 is already installed on your camera, then you do not need to proceed with this upgrade.

Be sure to read the section, “Modifications enabled with firmware version 1.1″, before updating your camera’s firmware.

As the downloaded firmware must be copied to an SD memory card to perform the firmware update, an SD memory card reader or similar device is required.

See the installation instructions for information on the equipment needed to perform the firmware update. If, for any reason, you are unable to update your camera’s firmware yourself, take your camera to an authorized Nikon service representative, where they will perform the update for you.

P80 Firmware Update v.1.1 - Windows

P80 Firmware Update v.1.1 - Macintosh

Share and Enjoy: These icons link to social bookmarking sites where readers can share and discover new web pages.